Important notes about Diskhaler®

The Diskhaler® pierces one blister of medicine at a time

Store at 25°C (77°F)

Always check the inside and outside of the mouthpiece to make sure it is clean and clear. Any foreign object in the mouthpiece could be inhaled and cause serious harm.

Remove the cover of the mouthpiece. Check inside and outside of the mouthpiece to make sure it is clean and clear.
Pull out the white tray gently with the edges of the white mouthpiece until you can see the ridges on each side of the tray.
Press both sides of the ridges at the same time and pull the white tray completely out of the Diskhaler® body.
Place one silver medicine disk on the wheel with the flat side facing up. The four blisters of the disk should fit neatly into the four holes in the wheel.
Slide back the white tray fully as far as it will go into the Diskhaler® body.
Life the lid (shaped like a half-circle) at the top of the Diskhaler® as far as it will go into a completely upright position. This lid must be in a straight upright position for the needle to pierce both the top and bottom of the medicine disk inside.
Click the lid down into position.
Breathe out away from the Diskhaler®. Keep the Diskhaler® at a level so the medicine does not spill out. Wrap and seal the mouthpiece with your lips without covering the air vents.
Breathe in steadily as strongly and deeply as you can until your lungs are full as much as you comfortably can.
Remove the Diskhaler® from your mouth and hold your breath for 5 to 10 seconds or as long as you comfortably can and then breathe out slowly.
Rotate the Diskhaler® to the next blister by gently pulling the white tray out and in again. Only piece the blister when you are ready to take the next inhalation.
Replace the mouthpiece cover.